APM 2.6 Case (Cables enter from side)

Apmsideentry1
This is the official case for the APM 2.5 system.  It's designed to keep your electronics safe while looking great at the same time!
The new APM 2.5 enclosure is made of black translucent ABS plastic. It protects your electronics while allowing access to all pins and connectors. The inside of the enclosure is lined with ESD safe open cell foam to ensure the barometric pressure sensor is surrounded by static air and prevent unwanted readings due to airflow over the sensor. The screws that secure the enclosure have been moved to the top for ease of use. The enclosure comes in two variants straight pins and angled pins. The side entry variant protects the I/O pins to protect them in the even of a crash.

The kit comes with the following:

-Foam cover for pressure sensor on APM 2.5.
-3x 6mm screws for the shorter corners of the case.
-1x 10mm screw for the longer corner of the case.
-4x 4mm screws to secure the APM 2.5 board to the base plate of the case.
-4x Rubber washers to help secure the APM 2.5 board to the base plate of the case (use with the 4mm screws).
-1x Reset button.

Assembly Instructions


This option is for the side entry case, depending on your current APM 2.5 set up.



NOTE: This product is compatible with APM 2.5 only! The APM 2.5 board is not included, it's included in the image only as a reference.